2000 Toyota Tundra How To Get Off The Drum Cover

Remove the wheel and tire on the side you want to work on first.

2000 toyota tundra how to get off the drum cover. They dont budge at all which makes me think this tundra is different from every car Ive owned since 1974. Bolt size is M8x125. Go to Jeep and buy a bearings seals and collar.

I just get out the hell box and find one. Fits 2000-2006 Toyota Tundra Rear Window Back Glass Stationary with 2 Sealants 16500 Milwaukee 48-22-8201 48 Pocket Ultimate Jobsite Backpack 9900. About a week later the Right was found to be dragging and I had to bang the drum off and back off the adjuster.

This must be cut off to get the old bearing and seal off. Be sure to back off the star adjuster in case a shoe had worn a groove in the drum which can also cause the drum to be stuck. Carefully dispose of the bulb to prevent it from cracking or shattering.

Still no luck beat it around the edges with a heavy rubber mallet. If they are like the early taco models there is an access slot coverd with a rubber plug so you to get a screw driver in there and back the adjuster off if necessary. Make sure the ebrake is off and pull.

Carefully cut through the original differential cover using an electric or pneumatic cutoff wheel around the circumference of the cover. Remove rear diff cover and wheel and start taking apart. If no luck back off the adjuster and try again.

I doubt like hell youll need one for an 05 anyway. 3 Release the retaining spring to loosen the old bulb and then pull it directly out of the socket. Conceals Rusty Components Stops Unsightly Brake Dust.