2000 Toyota Tundra Rear Bumper Removal

The tongue capacity of 500 lbs is the weight of the hitchball can take from gravity so you can drop 500 lbs onto the.

2000 toyota tundra rear bumper removal. After those bolts are removed you can pull the sides of the cover away from the quarter. Remove tail lamp four 8mm nut perside unplug wires. Next underneath the bumper there are 2 clips that you need to pull out with a flat head screw driver they point straight to the ground and are holding the bumper extenders in place Then the easy part remove the 14mm bolts 2 on each side attached to the frame.

This will soft the bumper so you push it out easily on the car. -assistant exempt corners of the latches in the wings and remove the bumper from the guides themselves-remove the connector from the fog lamp if any-remove connector from the PDC if any-if you have headlight washers disconnected the hoses so the liquid will not escape on earth should prepare a special container. Joined Dec 29 2008.

If you wish to remove the entire set up from the frame remove the bolts attaching the brackets to the frame rails. Remove the rear bumper. Remove the bumper arm-to-body bolts from each side of the bumper.

New Chrome Steel Rear Step Bumper Complete Assembly For 2000-2006 Toyota Tundra Fits. Rear bumper is pretty easy. Squeeze and push clamps 31 to remove rubber.

It should be a 10mm. Remove black clips under tail lamps flat head screwdriver to pull center of. Can someone please help me out I thought I saw it on this forum or maybe it was on another forum.

Removal of front bumper. Get the longest flat tip screw driver that you can and crawl underneath the truck and try to pop those little tabs out from the plastic bumper covers. I am going to paint mine this weekend.