2000 Toyota Tundra Starter Relay Problems
If you find the ign relay swap it with another non-critical relay test it.
2000 toyota tundra starter relay problems. However the motor inside the starter should turn on and make a loud humming sound. Sometimes starts right a way sometimes have to turn the ignition key - Toyota 2000 Tundra question. 1 disconnect battery 2 remove any wires connected to the starter 3 remove mounting bolts 4 catch the starter and manouver it through your suspincion 5 you may need to reverse 2 and 3 depending on how hard the wires are to get to 6 now revers these steps with new starter.
I just replaced the starter in my 02 Tundra with the 47 for the second time in November. I changed the computer key to a new one thinking the module in the key was bad. There is a 5amp starter fuse under the hood in the fuse panel make sure its good if it is remove the starter relay in the same fuse block the relay has numbered terminals identify terminal three on the relay and the corresponding connector in the fuse box apply 12volt battery voltage directly to terminal three of the socket with a jumper wire from the battery the starter should turn the engine.
I cleaned the battery terminals thinking they were dirty. That worked for a few days. I have a 2000 toyota tundra 4x4 access cab with the 47L v8.
Next time it clicks when it doesnt start take notice if the truck loses all powerthe dash lights shut off headlights off radio off etc if it loses power it is definitely a corrosion cable or bad cell in the battery problem. However yesterday i cleaned it all up and went to go start it and take it to a shop to get my rear stopping light fixed but it wouldnt. The next thing that I would do is to plug up a spark plug tester 5 at autozone up to the plugs and make sure that they are getting voltage.
2000 Tundra Turn key sometimes it starts sometimes a 1 or 2 second delay then starts sometimes nothing at all. About Press Copyright Contact us Creators Advertise Developers Terms Privacy Policy Safety How YouTube works Test new features Press Copyright Contact us Creators. At times the truck will not start and I will need to wait for approx 30 min and it will start.
However today the truck just wont start. That did not help. Before I replaced the starter what was happening was I would turn the key to start nothing would happen for a second or so then the starter would engage.