2000 Toyota Tundra Starter Relay Removal

Disconnect all the bolts that hold the starter to the block using a ratchet.

2000 toyota tundra starter relay removal. If the radiator is still warm allow it to cool off before you start next step. Chevron Techron Concentrate Plus Fuel System Cleaner - 20 oz. Lift the relay required me to use a screwdriver to get under the relay and pry it upwards from different angles until it got loose enough to be pulled up by hand.

Slide the starter back and rotate the solenoid toward you. Remove starter relayclosed a clip holds the relay in place release the clip and simultaneously lift the relay upwards. If you DO remove the intake you MUST replace the intake manifold gaskets or your engine.

Posted by Anonymous on Jun 24 2014. Remove the starter and power and signal leads replace with new or quality remanufactured installation is reverse procedure of removal. Turn off the ignition and remove the negative battery cable from the battery.

Remove the solenoid connection. Heres a bypass for those that dont have the starter relay on the wheel well. I am not responsible for any damages that occur upon watching this video.

Starter clicking but not turning over can only be caused by bad battery terminals. Park the Toyota Tundra on a level surface and set the parking brake. About Press Copyright Contact us Creators Advertise Developers Terms Privacy Policy Safety How YouTube works Test new features Press Copyright Contact us Creators.

Viewer understands that it is their sole responsible and liability for. Then with the engine off touch the radiator to gauge its temperature. 15 hours to remove and 45 minutes to replace.