2000 Toyota Tundra Tail Light Green Black Wire

Forums Tundra Discussion 25 Gen.

2000 toyota tundra tail light green black wire. One of the two wires is a ground likely black. On 6-Cylinder Engines The Tach Wire Is A Black On V-8 Engines The Tach Wire Is A BlueWhite Both Wires Are At The Instrument Cluster In A Brown Plug. Black housing smoke lens.

2 Hook up power to the backup camera using the red and black wires attaching them with a T-tap connector to the wires in the drivers side tail light assembly that power the reverse light. The light on your cap will only light up when the brake is pressed thats why theres only two wires. Then to address the two green wires find out which wire gets power only when the brake peddle is pressed.

On the 6-Cylinder the BLACK wire can be found at the Diagnostic connector drivers side of engine and on the 47L V8 engine you can use the BLACKBLUE wire at coil 1 on the Drivers side. When the right turn is activated the green wire should have an on-and-off blinking signal and the same should occur for left turn signals on the yellow wire. On 6-Cylinder engines the Tach wire is a BLACK on V-8 engines the Tach wire is a BLUEWHITE both wires are at the INSTRUMENT CLUSTER in a BROWN Plug.

Draw in GREEN the INPUTS which are used by the Integration Relay to control the lights. Tachometer Wire Negative Wire -. Connect this to the ground for your tail lights also likely the black wire.

TheHutchTTU Feb 24 2020 115. Tows my 165 Jayco JayFeather 2800lb trailer great. I have a 2000 toyota tundra limited edition.

Be extra sure that you tap your negative wire blue into the baby blue wire in the 4 spot in the top right wiring harness. If voltage is not available check the integration relay or the tail fuse. Whichever that wire is that is the one you want to hook up to your cap.