2001 Toyota Tundra Ignition Switch Removal

Customer was having trouble with the key not working in Ignition lock on a 2001 Toyota Tundra.

2001 toyota tundra ignition switch removal. ---- Automotive Locksmith Services in Atlanta GA Metro Area. Hanging lots of junk on a key ring will cause premature wear in an ignition lock. REMOVAL AND INSTALLATION Ignition Switch Removal.

This is the 4th time in the last 2 weeks this has occured so where do I. I can get the new ignition i just dont know how to remove the old one please help someone. Rotate ignition switch lock cylinder 11582 to the RUN position.

Slide the cylinder into the lock housing until the stop tab engages the hole in the lock. USUALLY though the problem is caused by pressure of the steering wheel lock bar on the cylinder. May apply to differnt Toyota vehicles as well2010 Toyota Tundra SR5.

Insert ignition key and turn to the accessory position. Ignition problems with a 2000 Tundra. Turn the lock cylinder into the Accessory position with the key and insert a small screwdriver into the hole at the bottom of the ignition switch casting.

If you turn the wheel enough to release the pressure the lock should turn. Luckily i have a remote starterso i am not completely out of commision. When I got ready to leave the Fed Ex place I had parked at the key would not turn in the ignition.

I bought one for 17 used at the Pick-n-Pull. Disconnect the ignition switch electrical connector. The two primary components in a Toyota trucks ignition system are the actual ignition switch and the lock cylinder which work with the ignition key.