2004 Toyota Tundra Parking Brake Adjustment

236-horsepower 40L V6 5-speed automatic RWD.

2004 toyota tundra parking brake adjustment. Tighten up the adjuster nut till the parking brake pedal has 9-13 clicks to set the brake. There are a few other Parking Brake Adjustment Threads on here in the 1st Gen Section. Was checking brakes for pulsating issue and during inspection they discovered that the right rear caliper had a broken bolt that could not be.

The 2004 Toyota Tundra has 1 NHTSA complaints for the parking brake at 109000 miles average. Seek those out and follow the directions per the Factory Service Manual Guide. Attached are two nuts that adjust the hand parking brake.

Parking Brake Cable are shipped directly from authorized Toyota dealers and backed by the manufacturers warranty. If there is still a problem pull the drum and inspect the linings for excessive. Replacing the parking brake cable can.

When you pull the parking brake if the adjusting plate can move one or more teeth it will tighten the brakes a little. There are two pieces to unscrew and remove. Remove the console covering from around the hand parking brake.

Brake Cables are responsible for application of the parking or emergency brake. If you think they are not adjusted try backing up and applying the brakes every few feet. It works the same on a Sienna as you described at least on the earlier models.

Toyota Tundra 2004 Parking Brake Cable by Dorman. Gently lock the vice grip on the front end of the threaded adjuster rod to keep it from turning and break the lock nut free on the other end. Shop OEM 2004 Toyota Part 464100C010 46410-0C010 464100C011.