2006 Toyota Tundra Drive Shaft Removal

EAG Fit for 03-06 Toyota Tundra Front Mesh Hood Grille Black Stainless Steel.

2006 toyota tundra drive shaft removal. In order to remove the driveshaft youll need a rubber or plastic tipped hammer. Toyota Tundra center support bearing replacement PART 1 httpsyoutubeWHfbG67Oo8cCenter support bearing replacement on driveshaft PART. The easiest way to locate it follow the positive battery cable down to it they are a bear to replace last thing I saw on them was you had to remove windshield wiper arms and all kinds of stuff to get to them heres what a guy listed on his 2006 If your Tundra has a 47 L v8 then be prepared for a long job.

There are 2 bolts holding it to the truck. Remove shaft from spindle. Driveshaft broke at the rear yoke.

Remove the front part of the driveshaft. 2 Toyota Tundra. Slide the driveshaft out of the slip yoke.

I made this video to TRYtoHELPyou out with knowing how to remove and install your driveshaft. All fit 2000-2021 Toyota Tundra and more. Remove the two 17mm bolts and the center of the driveshaft will drop down.

The front driveshaft is going to be attached solid inside the output shaft supports. This is in the middle of the driveshaft and seperates the 2 pieces of the driveshaft. BE CAREFUL and have your helper hold the driveshaft so that it does not injure one of you or gets damaged.

Next is the carrier bearing. All our 2006 Toyota Tundra Rear Drive Shaft inventory come with a 1-year warranty FREE shipping and 30-day money back guarantee. The starter is under the intake manifold and takes about 4 hours to take the intake manifold fuel injection.