2010 Toyota Tundra Oil Light Reset

Toyota Tundra Oil Maintenance Required Light Reset Guide For your information this process will work the first and second generations of the Toyota Tundra 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 model years.

2010 toyota tundra oil light reset. With vehicle ignition switched to ON position make sure odometer is showing Tripmeter A then turn the ignition switch to OFF position. I assume the warning light is still on if so get it scanned for fault codes. Press and hold trip meter reset knob and turn the ignition to the RUN position.

Ensure odometer reading is shown. Noticed that the low oil pressure lightoil can under the oil pressure gage is on. Took it to Toyota.

When replacing sensors and performing maintenance on a Toyota Tundra the engine control unit may not turn the indicator light off. With the Trip Reset button pushed down turn the ignition key to the ACC On position. The flashing dashboard light will go off and the reading on the odometer will reset.

Oil Change Light Reset Toyota Tundra 2010 2011 2012 2013 2014 2015 Procedure Turn the ignition to the RUN position. Do not drive the vehicle with the warning light oneven for one block. Resetting the ECU turns the indicator off and wipes out any codes the ECU may have.

With your left hand push the Trip Reset button. This is how you turn off the maintenance light on a Prius. Youll see the odometer flashing 5 lines then 4 then 3 2 and 1 until all the lines are gone.

This video shows you how to reset the Maintenance Light on a 2010 Toyota Tundra. Oil Viscosity and Capacity The 4 liter engine holds approximately 48 quarts 45. Turn the ignition off.