2000 Toyota Tundra Rear Axle Removal

10 mm wrench Third remove the drain and fill plugs from the axle and let the fluid drain out into a container for proper disposal.

2000 toyota tundra rear axle removal. I pulled the rear axles out today to be sent off and have new bearings pressed in and replace the tube seals. I have a 2002 tundra 47 l engine 2 wheel drive. Overall not a bad job.

Hello everyone Im the proud owner of an 03 Tacoma 4x4. Genuine Toyota Parts the Right Choice. Also you should replace the seals for the axles of if you are changing the bearings.

This will expose the parking brake cable end shown below. They cant seem to get the bearing and housing to bust loose from the axle. On AmazonREAR WHEEL BEARING KIT.

When a rear axle seal goes bad its typically noticeable by gear oil leaking all over a rear wheel and it may get into the brake drum and reduce rear brake feel. Remove e-brake cable from rear drum and take off brake linecarefully. I recomend draining and changing your rear differential fluid too because if the fluid by run out of axle housing.

Fits 4Runner T100 Tacoma Truck TundraAxle Shaft Bearing - Repair or ReplaceAn Axle Shaft bearing can fail and result in a squeak or chirp noise or possibly as a whine or groan that can be mistaken for a wheel bearing noise. The lines are directly above the axle. Im installing a rear axle bearing oil seals on my 1985 Toyota Pickup 4x4 without using a press.

Toyota Tundra Forum. Schemes of fastening of front and rear bumpers. 2000 Tundra Limited 4x4 1100 Build 32 lift visor 2857516 eibach pro-truck Cvj axles custom lighting.